26dB Micro Amp Boost Pedal

Model: FXBOMBP

Input Jack - Connect a cord from your instrument here. Removing the cord from the INPUT jack when not in use disconnects the battery which will prolong battery life
Output Jack - Connect a cord out to your amplifier here.
9V Input - Connect an optional power supply here. Accepts an industry standard 9 Volt regulated DC supply with a 2.1mm barrel type connector, center contact negative. The Whirlwind PS9V-EFX power supply is recommended for proper operation.
Controls the amount of boost applied to the signal. At full counter-clockwise ("1"), there is no boost, the unit is at unity gain. As the knob is turned up, the gain gradually increases until it reaches +26 dB of gain at full up ("11").
Status LED - Illuminates when the effect is active.

More Product Information Below

Compare

Project List

Product Info

Tech Specs

Documents

26dB micro amp boost pedal is a good old American boost with true bypass, a bright LED, and a 9V power input. This power house of a pedal couldn't be simpler, one knob dials your volume boost from 1 to 11, which takes you from a gentle increase in volume and gain, for those subtle acoustic solos, all the way to eleven giving you as much boost as you can handle! The Bomb is also a great way to give your effects line a little added horse power to get the job done and drive your point home. Proof again, that big things definitively do come in small packages.

Input Jack - Connect a cord from your instrument here. Removing the cord from the INPUT jack when not in use disconnects the battery which will prolong battery life
Output Jack - Connect a cord out to your amplifier here.
9V Input - Connect an optional power supply here. Accepts an industry standard 9 Volt regulated DC supply with a 2.1mm barrel type connector, center contact negative. The Whirlwind PS9V-EFX power supply is recommended for proper operation.
Controls the amount of boost applied to the signal. At full counter-clockwise ("1"), there is no boost, the unit is at unity gain. As the knob is turned up, the gain gradually increases until it reaches +26 dB of gain at full up ("11").
Status LED - Illuminates when the effect is active.
Footswitch - Turns the effect on and off. When OFF, the unit is completely removed from the signal path (TRUE BYPASS).
Battery Compartment - Remove 4 screws on the bottom of the unit to access the battery. Be sure to leave the protective insulator in place to prevent the circuit board from contacting the metal case.